Speedhut 2-1_16 inch & 2-5_8 inch Speedometer Bedienungsanleitung PDF herunterladen

(black)

Installation

1.Disconnect negative (-) Battery Cable

2.Connect wiring as above.

3.Mount Gauge for easy viewing. Use spin lock

ring (included) to mount to panel.

4.Reconnect negative (-) battery cable.

+12 volts keyed ignition

(Red)

(Black)

Ground

(White)

+12 volts Dash lighting

(dial lighting wire)

Ground (black)

+12 volts Dash lighting (white)

snap connector

(Pointer lighting wire)

White wire speedometer

pulse signal. Acceptable

signals ranging from

5V-100Volts.

0-7500 htz frequency.

Black wire (optional)

sensor ground.

If your Sensor has a

ground terminal,

hook up to black wire.

Programming Button

Calibration Proceedure

The calibration proceedure is done while the vehical is driving at a known speed. This can be done by following another vehical at a safe distance driving

at a known speed for example. Please have a co passenger right with to perform calibration on speedometer for safetly.

1. Turn on gauge power and start engine while in park.

2. Hold button down for 10-12 seconds. Until needle swings 1/2 scale.

3. Use button to toggle pointer up and down to the desired mph you would like to calibrate at. Example: If you would like to calibrate your speed while driving

45mph, toggle button until it is right at 45mph.

4. Release button. You will see the needle oscillate around the desired set point indicating it is ready to calibrate.

5. Start driving up to desired set point speed. Hold speed constant. Watch road NOT Gauge!

6. Press and hold button for 2-3 seconds to store setting. Calibration is complete.

Gauge should zero and then immediately move up to the current mph setting.

(Main gauge power)

WARRANTY - Speedhut inc. warrants to the consumer for a period of 5 years from the date of purchase that the product will be free from defects in materials or workmanship.

Speedhut warrants to the consumer for a "LIFE-TIME" that the gauge circuit board will be free from defects in materials or workmanship. Please contact Speedhut service dept.

If you have a problem with this gauge. suppor[email protected]om

2-1/16" and 2-5/8" Speedometer Instructions

Note: Tie both lighting white wires together

and both black ground wires together.

INVERTER IS REQUIRED FOR GAUGE DIAL LIGHTING

INVERTER

Power Draw = 0.2 Amp

5 Amp Inline Fuse Recommended

for +12 Keyed Ignition

Programming Button 1

Inhaltsverzeichnis

Seite 1 - Programming Button

(black)Installation1.Disconnect negative (-) Battery Cable2.Connect wiring as above. 3.Mount Gauge for easy viewing. Use spin lock ring (included) t

Kommentare zu diesen Handbüchern

Keine Kommentare

Speedhut 2-1_16 inch & 2-5_8 inch Speedometer Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Für das Auto Speedhut 2-1_16 inch & 2-5_8 inch Speedometer herunter. Speedhut 2-1_16 inch & 2-5_8 inch Speedometer User Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Für das Auto Speedhut 2-1_16 inch & 2-5_8 inch Speedometer